OLT
command line
1. check ont status
show gpon onu state gpon-olt_1/2/3
2. check ont power
show pon power attenuation gpon-onu_1/2/3:18
3. check power interface
show interface optical-module-info gpon-olt_1/1/1
4. check ont mac address
show mac gpon onu gpon-onu_1/2/3:18
5. chesk ont uptaime and ont history logs
show gpon onu detail-info gpon-onu_1/2/3:18
6. find ont by SN number
show gpon onu by sn ZTEGC123456F
7. check ont version
show gpon remote-onu equip gpon-onu_1/2/3:18
8. check OLT uptime
show system-group
9. check olt board
show card
10. check OLT prosessor and memory
show processor
11.check olt card temperature
show card-temperature
12. check olt per slot
show card slotno 2
13. check ont ip routing mode
show gpon remote-onu ip-host gpon-onu_1/2/1:3
14. check ont konfig
show run int gpon-onu_1/4/1:2
15. reboot ont
config t pon-onu-mng gpon-onu_1/2/1:3 reboot
16. reset factory ont
config t pon-onu-mng gpon-onu_1/2/1:3 restore factory
17. disable/shutdown port ont
config t pon-onu-mng gpon-onu_1/2/1:3 interface eth eth_0/2 state lock --> disable/shutdown port number 2
18. enable/shutdown port ont
config t pon-onu-mng gpon-onu_1/2/1:3 interface eth eth_0/2 state unlock --> enable port number 2
19. release renew ont as dhcp client
config t >>Enter configuration commands, one per line. End with CTRL/Z. pon-onu pon-onu-mng gpon-onu_1/2/1:3 ip-host 1 dhcp-enable false ping-response false traceroute-response false ip-host 1 dhcp-enable true ping-response true traceroute-response true
20. check rx/tx level uplink port
sho int optical-module-info xgei_1/21/1
21. reset slot card
reset-card slotno 2
22. swap
Use This for First Level Handling when you get Anomaly Process. sometimes it can help you, but sometime isn’t
swap
23. show vlan summary
show vlan summary
24. check bandwidth profil
show gpon profile traffic